中国机械工程 ›› 2010, Vol. 21 ›› Issue (12): 1481-1484.

• 材料工程 • 上一篇    下一篇

深海高压环境下的密封材料变形特性分析

周博;陈家旺;顾临怡
  

  1. 浙江大学流体传动与控制国家重点实验室,杭州,310027
  • 出版日期:2010-06-25 发布日期:2010-07-01
  • 基金资助:
    国家863高技术研究发展计划资助项目(2006AA09A206,2006AA09Z241);中国科学院科研装备研制和改造项目(Y2005010)
    National High-tech R&D Program of China (863 Program) (No. 2006AA09A206,2006AA09Z241)

Analysis on Self-compressibility of Sealing Materials under High Pressure in Deep-sea

Zhou Bo;Chen Jiawang;Gu Linyi
  

  1. The Key State Laboratory of Fluid Power and Transimission Control,Zhejiang University,Hangzhou,310027
  • Online:2010-06-25 Published:2010-07-01
  • Supported by:
    National High-tech R&D Program of China (863 Program) (No. 2006AA09A206,2006AA09Z241)

摘要:

深海各种实验仪器的密封特性受高压环境的影响存在自身压缩的可能性。推导出了轴向压缩率的计算公式,应用试验台架对氟橡胶、硅橡胶、丁腈橡胶三种密封材料进行了轴向压缩试验。试验结果表明,深海高压环境(水深10 000m,即水压100MPa之内)下密封材料自身压缩率小于6%,因此在设计高压环境下的密封结构时仍可以按常压密封结构进行设计(密封槽、密封圈选型等),但出于安全考虑,密封圈当量直径可适当放大10%。

关键词:

Abstract:

The deep-sea experimental instruments' sealing performances are influenced by the self-compressibility under high pressures.The authors deduced the formula of calculating the axial compression ratio,and did the axial compression experiments on the following three kinds of sealing materials: fluorine rubber, silicone rubber and nitrile butadiene rubber, which shows the self-compressibility of sealing materials is less than 6% under the deep-sea high pressure (10 000 m means 100MPa). Therefore the principles of designing sealing structures at atmospheric pressure can be adopted(sealed slot, O-ring selection, etc.);however,the O-ring equivalent diameter should be appropriately enlarged by 10% for the sake of security.

Key words: deep-sea high pressure;rubber-ring, self-compressibility, high pressure experiment

中图分类号: