磁轴承激励下转子系统动力学特性

doi:10.3969/j.issn.1004-132X.2021.08.003

摘要/Abstract

摘要： 为分析磁轴承激励下转子系统的振动机理，应用一维有限元方法建立了双盘转子系统动力学特性计算模型，研究了不同类型磁轴承激励下转子系统的动力学行为。研究结果表明：同向旋转的扫频激励力激发了转子系统的正进动模态，而反向旋转的扫频激励力激发了转子系统的反进动模态，两种情况下转子系统均以圆轨迹进动；由于单向简谐激励力可以分解为同向旋转激励力和反向旋转激励力之和，因此在单向简谐扫频激励力作用下，转子系统的反进动和正进动模态均被激发，转子系统以椭圆轨迹进动；在双向简谐扫频激励力作用下，转子系统的进动方向和进动轨迹取决于两个激励力的相位差。研究成果为评估高压压缩机转子系统稳定性时磁轴承激励方案的选取提供了理论依据。

关键词: 转子系统, 磁轴承, 简谐激励, 正进动, 反进动

Abstract: To analyze the vibration mechanism of the rotor systems excited by magnetic bearings, a calculation model for dynamics characteristics of a double-disk rotor system was established by using one-dimensional finite element method. The dynamics behaviors of rotor system under different types of magnetic bearing excitations were studied. Results show that the co-rotating sweep frequency exciting forces excite forward whirl mode of the rotor systems, while the counter-rotating sweep frequency exciting forces excite backward whirl mode. In both cases, the rotor system whirls in a circular trajectory. The unidirectional harmonic exciting force may be decomposed into the sum of co-rotating and counter-rotating exciting forces, therefore both of the backward whirl and forward whirl modes of the rotor system are excited and the rotor system whirls with an elliptical trajectory under the effect of unidirectional harmonic sweep exciting force. Under bi-directional harmonic sweep exciting forces, the whirl direction and whirl trajectory of the rotor system depend on the phase difference of the two exciting forces. Research results provide a theoretical basis for the selection of excitation scheme of magnetic bearings when evaluating the stability of rotor systems of high-pressure compressor.

Key words: rotor system, magnetic bearing, harmonic excitation, forward whirl, backward whirl

中图分类号:

TB652

李胜远, 郑龙席. 磁轴承激励下转子系统动力学特性[J]. 中国机械工程, 2021, 32(08): 901-907.

LI Shengyuan, ZHENG Longxi. Dynamics Characteristics of Rotor Systems under Magnetic Bearing Excitation[J]. China Mechanical Engineering, 2021, 32(08): 901-907.

导出引用管理器 EndNote|Ris|BibTeX

链接本文: http://www.cmemo.org.cn/CN/10.3969/j.issn.1004-132X.2021.08.003

http://www.cmemo.org.cn/CN/Y2021/V32/I08/901

参考文献

［1］ATKINS K E, PEREZ R X. Assessing Rotor Stability Using Practical Test Procedures［C］//Proceedings of the 21st Turbomachinery Symposium. Texas, 1992:151-159.

［2］宁喜, 王维民, 张娅, 等. 离心式压缩机密封动态特性分析及稳定性评价［J］.振动与冲击, 2013, 32(13):153-158.

NING Xi, WANG Weimin, ZHANG Ya, et al. Dynamic Performance Analysis of Seals in a Centrifugal Compressor and Rotor System Evaluation［J］. Journal of Vibration and Shock, 2013, 32(13):153-158.

［3］孙正兰. 离心压缩机转子动力系统的稳定性研究［J］. 风机技术, 2013(2):24-27.

SUN Zhenglan. Stability Analysis of Rotor Dynamic System for Centrifugal Compressors［J］. Chinese Journal of Turbomachinery, 2013(2):24-27.

［4］American Petroleum Institute. Axial and Centrifugal Compressors and Expander-compressors: API Standard:API 617—2014［S］. Washington D C: American Petroleum Institute, 2014:1-374.

［5］乔晓利,祝长生,钟志贤.基于主动磁轴承的切削颤振稳定性分析及控制［J］.中国机械工程,2016,27(12):1632-1637.

QIAO Xiaoli, ZHU Changsheng, ZHONG Zhixian. Stability and Control for Cutting Chatter Based on Active Magnetic Bearings［J］. China Mechanical Engineering, 2016,27(12):1632-1637.

［6］BAUMANN U. Rotordynamic Stability Tests on High-pressure Radial Compressors［C］//Proceedings of the 28th Turbomachinery Symposium. Texas, 1999:115-122.

［7］TAKAHASHI N, MAGARA Y, NARITA M, et al. Rotordynamic Evaluation of Centrifugal Compressor Using Electromagnetic Exciter［J］. Journal of Engineering for Gas Turbines and Power, 2012, 134(3): 32505.

［8］MOORE J J, WALKER S T, KUZDZAL M J. Rotordynamic Stability Measurement during Dull-load, Full-pressure Testing of a 6000 Psi Reinjection Centrifugal Compressor［C］//Proceedings of the 31st Turbomachinery Symposium. Texas, 2002:29-38.

［9］MOORE J J, SOULAS T A. Damper Seal Comparison in a High-pressure Re-injection Centrifugal Compressor during Full-load, Full-pressure Factory Testing Using Direct Rotordynamic Stability Measurement［C］//ASME 2003 International Design Engineering Technical Conferences and Computers and Information in Engineering Conference. Chicago, 2003:1319-1326.

［10］BIDAUT Y, BAUMANN U, Al-HARTHY S M H. Rotordynamic Stability of a 9500 Psi Reinjection Centrifugal Compressor Equipped with a Hole Pattern Seal-measurement versus Prediction Taking into Account the Operational Boundary Conditions［C］//Proceedings of the 38th Turbomachinery Symposium. Texas, 2009:251-259.

［11］SOROKES J M, SOULAS T A, KOCH J M, et al. Full-scale Aerodynamic and Rotordynamic Testing for Large Centrifugal Compressors［C］//Proceedings of the 38th Turbomachinery Symposium. Texas, 2009:71-79.

［12］SOULAS T A, KUZDZAL M J. Rotordynamic Testing and Evaluation of a Large Centrifugal Compressor Using a Magnetic Bearing Exciter［C］//ASME Turbo Expo 2009: Power for Land, Sea, and Air. Orlando，2009:1055-1062.

［13］PETTINATO B C, CLOUD C H, CAMPOS R S. Shop Acceptance Testing of Compressor Rotordynamic Stability and Theoretical Correlation［C］//Proceedings of the 39th Turbomachinery Symposium. Texas, 2010:31-42.

［14］张天程, 曹树谦, 李利青,等. 碰摩双转子系统弯扭耦合振动分析与实验［J］. 航空动力学报, 2019, 34(3):643-655.

ZHANG Tiancheng, CAO Shuqian, LI Liqing, et al. Analysis and Experiment of Coupled Bending and Torsional Vibration of a Rub-impact Dual Rotor System［J］. Journal of Aerospace Power, 2019, 34(3):643-655.

［15］GREEN K, CHAMPNEYS A R, LIEVEN N J. Bifurcation Analysis of an Automatic Dynamic Balancing Mechanism for Eccentric Rotors［J］. Journal of Sound and Vibration，2006, 291(3/5):861-881.

［16］NELSON H D, MCVAUGH J M. Dynamics of Rotor-baring Systems Using Finite-elements［J］. Journal of Manufacturing Science and Engineering，1976, 98(2):593-600.

［17］李胜远, 郑龙席, 贾胜锡, 等. 脉冲爆震载荷作用下转子系统动力学特性［J］.航空动力学报, 2019, 34(9):1936-1943.

LI Shengyuan, ZHENG Longxi, JIA Shengxi, et al. Dynamic Characteristics of Rotor System Subjected to Pulse Detonation Aerodynamic Loads［J］. Journal of Aerospace Power,2019, 34(9):1936-1943.

［18］宋晓光, 崔立, 郑建荣. 斜齿轮柔性转子轴承系统非线性动力学分析［J］.中国机械工程, 2013,24(11):1484-1488.

SONG Xiaoguang, CUI Li, ZHENG Jianrong. Nonlinear Dynamics Analysis of Flexible Rotor Bearing System with Helical-gear［J］. China Mechanical Engineering, 2013,24(11):1484-1488.

［19］张磊,裴世源,徐华,等.摇摆工况下错位瓦轴承支撑的转子系统动力学特性［J］.中国机械工程,2017,28(18):2161-2170.

ZHANG Lei, PEI Shiyuan, XU Hua, et al. Dynamics Characteristics of Rotor System Supported by Offset Bearings under Rolling Conditions［J］. China Mechanical Engineering, 2017, 28(18):2161-2170.

［20］FRISZZWELL M I, PENNY J E T, LEES A W, et al. Dynamics of Rotating Machines［M］. New York:Cambridge University Press, 2010:251-253.

[1]	牛斌, 闫家铭, 毛玉明, 刘海洋. 面向动力学性能的薄壁加筋板结构阻尼与筋条布局协同优化设计[J]. 中国机械工程, 2021, 32(16): 1912-1920.
[2]	王东雄, 王念先, 陈奎生. 磁悬浮双转子系统的定点碰摩特性[J]. 中国机械工程, 2021, 32(14): 1686-1699.
[3]	王志永;杜伟涛. 螺旋锥齿轮铣齿机主轴\\|轴承系统的动力学分析[J]. 中国机械工程, 2019, 30(18): 2211-2216,2223.
[4]	潘勇1;王香耿1;程敏2,3;刘保国2. 考虑稳定性的非线性刚度转子系统振幅突变分叉集分析[J]. 中国机械工程, 2017, 28(20): 2441-2447.
[5]	王广斌, 杜晓阳, 罗军, . 面向转子故障特征提取的多尺度拉普拉斯特征映射方法[J]. 中国机械工程, 2016, 27(20): 2791-2797.
[6]	王江辉, 徐武彬, 李冰, 李小磊. 判别非线性滑动轴承转子系统临界转速新方法[J]. 中国机械工程, 2016, 27(14): 1964-1968.
[7]	乔晓利, 祝长生, 钟志贤. 基于主动磁轴承的切削颤振稳定性分析及控制[J]. 中国机械工程, 2016, 27(12): 1632-1637.
[8]	孟华, 刘保国, 李鸽鸽. 中介轴承随机参数对双转子系统特征值的影响[J]. 中国机械工程, 2016, 27(05): 680-684.
[9]	黑棣, 吕延军, 张永芳. 有限长轴承支撑的转子系统非线性动力学分析[J]. 中国机械工程, 2015, 26(19): 2633-2640.
[10]	崔立, 郑建荣 . 柔性转子滚动轴承系统混沌行为研究[J]. 中国机械工程, 2014, 25(3): 393-398.
[11]	田录林, 李鹏. 锥形永磁轴承磁力解析模型[J]. 中国机械工程, 2014, 25(3): 327-332.
[12]	罗颂荣, 程军圣, 杨宇. 多尺度高阶奇异谱熵和GA-VPMCD方法在转子故障智能诊断中的应用[J]. 中国机械工程, 2014, 25(21): 2912-2917,2924.
[13]	宋晓光1, 崔立1, 2, 郑建荣1. 斜齿轮柔性转子轴承系统非线性动力学分析[J]. 中国机械工程, 2013, 24(11): 1484-1488,1493.
[14]	曾海景, 徐武彬, 魏塬, 张宏献, 胡君君. 圆度误差对滑动轴承-转子系统摩擦功率损耗的影响[J]. 中国机械工程, 2012, 23(8): 906-909.
[15]	汪波, 邓智泉, 赵旭升, 刘程子, 华春. 基于精确磁路的永磁偏置轴向径向磁轴承设计[J]. 中国机械工程, 2012, 23(17): 2036-2040,2047.