Analysis of Low Frequency Vibration Characteristics of Locally-resonant Vibration Isolation Systems

doi:10.3969/j.issn.1004-132X.2022.03.007

Abstract

Abstract: To effectively reduce the impact of low-frequency vibration of the base on measurement accuracy of precision instruments， a vibration attenuation method of periodically arranged absorbers was proposed. The dynamics model of substrate-vibration isolation equipment-vibration absorber system was established， the analytical solution of coupled vibration equation of the systems was derived by modal superposition method and verified by finite element method. The influence laws of number and parameters of vibration absorbers on low frequency vibration performance of the systems were obtained， when the total number of vibration absorbers was fixed， which was divided into several periodic cells with different number of resonators. Taking 0.7 times of the maximum amplitude and 0.3 times of the average amplitude as objective function， the parameters of resonator in cell were optimized by PSO algorithm. Results show that within the target frequency range， the relative errors between the analytical solution and the finite element one are as 4.39% and 2.98% respectively. Within the target frequency range， for the single-resonator cell， the vibration attenuation performance with 5 resonators is the best and the vibration attenuation efficiency is as 11.34%. When the mass ratio， natural frequency ratio and damping ratio of the absorber are around 0.16， 0.8 and 0.18 respectively， the vibration attenuation performance is the best， and the damping efficiencies are as 10.46%， 8.69% and 12.20% respectively. The vibration attenuation efficiency of optimized single-resonator， double-resonator， and triple-resonator cells may achieve 12.45%， 18% and 18.3% respectively.

Key words: locally-resonant, vibration isolation, low frequency vibration, analytical method, particle swarm optimization（PSO）

摘要： 为有效降低基体低频振动对精密仪器测量精度的影响，提出了周期布置吸振器的减振方式。建立了基体-隔振设备-吸振器系统的动力学模型，利用模态叠加法导出了系统耦合振动方程的解析解，并用有限元法进行了验证。获得了吸振器数量、参数对系统低频振动特性的影响规律，在吸振器总数一定的情况下，将其划分为包含不同数量振子的周期元胞。以低频段设备振幅最大值的0.7倍和平均值的0.3倍之和为目标函数，利用粒子群算法对元胞中振子的参数进行了优化。结果表明，在目标频段，解析解与有限元解之间的相对误差分别为4.39%和2.98%；在目标频段，针对单振子元胞，采用5个吸振器减振性能最优，减振效率为11.34%，吸振器质量比、固有频率比、阻尼比分别在0.16、0.8、0.18附近取值时减振性能最优，减振效率分别为10.46%、8.69%、12.20%；优化后的单振子、双振子、三振子元胞的减振效率可分别达到12.45%、18%、18.3%。

关键词: 局域共振, 隔振, 低频振动, 解析法, 粒子群优化

CLC Number:

TB535.1

GAO Shengyao, GUO Peng, ZHOU Qizheng. Analysis of Low Frequency Vibration Characteristics of Locally-resonant Vibration Isolation Systems[J]. China Mechanical Engineering, 2022, 33(03): 310-317,347.

高晟耀, 郭彭, 周奇郑. 局域共振型隔振系统的低频振动特性分析[J]. 中国机械工程, 2022, 33(03): 310-317,347.

References

［1］于梅. 精密仪器环境振动测量和评价方法的研究［J］. 振动与冲击， 2010， 29（8）：214-216.
YU Mei. Research Review on Measurement and Evaluation Methods of Environmental Vibration for Precision Instruments［J］. Journal of Vibration and Shock， 2010， 29（8）：214-216.
［2］WOLF S. Potential Low Frequency Ground Vibration（＜6. 3 Hz）Impacts from Underground LRT Operations［J］. Journal of Sound and Vibration， 2003， 267（3）：651-661.
［3］孙晓静，刘维宁，郭建平，等. 地铁列车振动对精密仪器和设备的影响及减振措施［J］. 中国安全科学学报， 2005， 15（11）：78-81.
SUN Xiaojing， LIU Weining， GUO Jianping， et al. Vibration Impact on Sensitive Instrument and Equipment Due to Metro Train and Its Reduction Measures［J］. China Safety Science Journal， 2005， 15（11）：78-81.
［4］车毕琴，郭中泽，赖盛景，等. 精密电子设备的减振设计与试验研究［J］.机械设计，2015， 32（9）：101-104.
CHE Biqin， GUO Zhongze， LAI Shengjing， et al. Vibration Reducing Design and Test Study of Precision Electronic Device［J］. Journal of Machine Design， 2015， 32（9）：101-104.
［5］丁继超，何立东，冀沛尧，等. 多重动力吸振器控制单跨转子振动实验研究［J］. 机电工程， 2019， 36（1）：13-17.
DING Jichao， HE Lidong， JI Peiyao， et al. Experimental Study on Controlling Vibration of Single-span Rotor Using Multiple Dynamic Vibration Absorbers［J］. Journal of Mechanical & Electrical Engineering， 2019， 36（1）：13-17.
［6］LIU Z Y， ZHANG X X， MAO Y W， et al. Locally Resonant Sonic Materials［J］. Science， 2000， 289（5485）：1734-1736.
［7］HIRSEKORN M. Small-size Sonic Crystals with Strong Attenuation Bands in the Audible Frequency Range［J］. Applied Physics Letters， 2004， 84（17）：3364-3366.
［8］温激鸿，郁殿龙，王刚，等. 周期结构细直梁弯曲振动中的振动带隙［J］. 机械工程学报， 2005， 41（4）：1-6.
WEN Jihong， YU Dianlong， WANG Gang， et al. Elastic Wave Band GAPS in Flexural Vibrations of Straight Beams［J］. Journal of Mechanical Engineering， 2005， 41（4）：1-6.
［9］王刚，温激鸿，温熙森，等. 细直梁弯曲振动中的局域共振带隙［J］. 机械工程学报， 2005， 41（10）：107-110.
WANG Gang， WEN Jihong， WEN Xisen， et al. Locally Resonant Elastic Wave Band GAPS in Flexural Vibrations of Slender Beams［J］. Journal of Mechanical Engineering， 2005， 41（10）：107-110.
［10］SANGIULIANO L， CLAEYS C， DECKERS E. Influence of Boundary Conditions on the Stop Band Effect in Finite Locally Resonant Metamaterial Beams［J］. Journal of Sound and Vibration， 2020， 473：115225.
［11］刘耀宗，郁殿龙，赵宏刚，等. 被动式动力吸振技术研究进展［J］. 机械工程学报， 2007， 43（3）：14-21.
LIU Yaozong， YU Dianlong， ZHAO Honggang， et al. Review of Passive Dynamic Vibration Absorbers［J］. Journal of Mechanical Engineering， 2007， 43（3）：14-21.
［12］KOLLURU K， AXINTE D， BECKER A. A Solution for Minimising Vibrations in Milling of Thin Walled Casings by Applying Dampers to Workpiece Surface［J］. CIRP Annals—Manufacturing Technology， 2013， 62（1）：415-418.

[1]	RONG Yu, CHEN Gang, DOU Tianci, . A Multi Index Comprehensive Optimal Anti Impact Trajectory Planning Method [J]. China Mechanical Engineering, 2024, 35(02): 305-316.
[2]	GUO Peng, ZHOU Qizheng, LUO Ziyin, LI Jian. Low Frequency Vibration Reduction Method of Ship Floating Rafts Based on Local Resonance [J]. China Mechanical Engineering, 2022, 33(17): 2046-2052，2060.
[3]	JI Li, MA Xueqing, CHEN Zhenmin. Low Frequency Vibration Mechanism for AMB High-speed Motor Rotor Systems and Its Compensation Strategy [J]. China Mechanical Engineering, 2022, 33(17): 2053-2060.
[4]	ZHANG Long, CAI Binghuan, XIONG Guoliang, WANG Chaobing, HU Junfeng. Multi-stage Noise Reduction Method with ESMK for Adaptive Feature Extraction of Rolling Bearings [J]. China Mechanical Engineering, 2021, 32(24): 2950-2959.
[5]	ZHANG Ying, SUN Hao, MA Shuaishuai. Design of a Kind of Multi-dimensional Attitude Adjustment and Vibration Isolation Platform Based on 4-UPS/CPC Parallel Mechanisms#br# [J]. China Mechanical Engineering, 2021, 32(13): 1513-1522,1529.
[6]	YU Ning, SUN Yexin, CHEN Hongyue. Prediction Method of Cutting Loads of Shearers Based on Multi-source Data Fusion [J]. China Mechanical Engineering, 2021, 32(10): 1247-1253,1259.
[7]	LIU Yong, ZHOU Yifan, XU Kaitong, JIANG Wei. New Variable Stiffness Vibration Isolation Method for Vehicle Power Packs [J]. China Mechanical Engineering, 2021, 32(06): 741-747,755.
[8]	LIU Tao;ZHANG Lifang. Parameter Solution of Instantaneous Milling Force Model of Variable Cross-section Scroll Plates Based on Improved PSO Algorithm [J]. China Mechanical Engineering, 2020, 31(24): 2943-2949.
[9]	WU Chongjian;YAN Xiaojie;DU Kun;CHEN Zhigang;HUANG Xichun;FU Aihua;ZHENG Lijie. Integrated Design of Vibration Isolation and Anti-shock for Complex System Reconstruction by Using System Emergence [J]. China Mechanical Engineering, 2020, 31(23): 2773-2779.
[10]	ZHAO Ting;XIAO Jiming;FAN Simin;YANG Zhenchao;YANG Fujie. Study on Chip Shapes and Drilling Forces of Low Frequency Vibration Drilling of TC4 Titanium Alloy [J]. China Mechanical Engineering, 2020, 31(19): 2276-2282.
[11]	ZHANG Qinglei1;ZHANG Fan2;DUAN Jianguo1. Layout Optimization of Large Marine Power Component Production Workshops Based on DMPSO Algorithm [J]. China Mechanical Engineering, 2020, 31(03): 344-351.
[12]	SUN Minghan;XU Zhe;ZHENG Likang;XU Zhiqiang;DU Fengshan. Optimization of Twin-roll Thin Strip Vibrating Casting Screw-down Control Systems Based on Improved PSO Algorithm [J]. China Mechanical Engineering, 2020, 31(03): 360-366.
[13]	ZHOU Youhang;MA Zhuxi;SHI Xuanwei;KONG Tuo. Defect Detection Method of Linear Guide Surfaces Based on HSI Color Space [J]. China Mechanical Engineering, 2019, 30(18): 2179-2184.
[14]	LIN Xiankun1,2;ZHANG Liming1. Acceleration Saturation Performance Optimization Method of Direct Feed Drive Systems Using Hybrid PLS Regression and PSO [J]. China Mechanical Engineering, 2019, 30(18): 2224-2230.
[15]	WANG Ronglin1;LU Baochun1;HOU Runmin1;GAO Qiang1;ZHANG Wei2;ZHU Yun3;DAI Lian3. FOPID Improved ADRC in AC Servo Systems [J]. China Mechanical Engineering, 2019, 30(16): 1989-1995.