Isotropy Design and Vibration Reduction of a Three-dimensional Dynamics Vibration Absorber Based on Parallel Mechanisms

doi:10.3969/j.issn.1004-132X.2023.03.007

Abstract

Abstract: Aiming at the multi-dimensional line-spectra coupling vibration control of power machines, a novel three-dimensional DVA was presented based on parallel mechanisms. The novel DVA has the merits of good modularity and small additional mass. On the basis of the establishment of dynamics model in terms of a set of joint coordinates, the modal analytical solution for modal analysis of the DVA was derived, leading to the condition to achieve dynamics isotropic design, and thereby a three-dimensional DVA reducing the line spectra vibration at 50 Hz was obtained. In addition, the effectiveness and advantages of the novel DVA in the applications on line-spectra vibration suppression of power machines were investigated. The results show that the maximum attenuations of the line spectrum response at around 50 Hz along three mutual vertical directions are all above 7 dB after the installation of the three-dimensional DVA, while only the line spectrum response along the direction of freedom may be suppressed effectively after the installation of the unidirectional DVA.

Key words: dynamics vibration absorber(DVA), parallel mechanism, dynamics isotropy, line-spectra vibration

摘要： 针对动力机械设备的多维线谱耦合振动控制问题，提出一种基于并联机构的三维动力吸振器，它具有模块化、附加质量小等优点。构造出采用一组关节坐标刻画的动力学方程，在此基础上推导出该新型动力吸振器的模态解析解，得到动力学各向同性条件，并据此设计出一款可抑制50 Hz线谱振动的动力吸振器。探讨了该动力吸振器在动力机械设备多维线谱耦合振动控制中的有效性及优势。分析结果表明：不同于单向动力吸振器仅能抑制其自由度方向的线谱振动，新型三维动力吸振器在三个垂直方向上对50 Hz附近线谱振动的最大减振效果均高于7 dB。

关键词: 动力吸振器, 并联机构, 动力学各向同性, 线谱振动

CLC Number:

TH113

DONG Chenglin, CAI Longqi, LI Yi, LU Tong, ZHANG Luke. Isotropy Design and Vibration Reduction of a Three-dimensional Dynamics Vibration Absorber Based on Parallel Mechanisms[J]. China Mechanical Engineering, 2023, 34(03): 307-313.

董成林, 蔡龙奇, 李毅, 路彤, 张路科. 基于并联机构的三维动力吸振器各向同性设计及减振特性研究[J]. 中国机械工程, 2023, 34(03): 307-313.

References

［1］贺辉雄，向阳，张波. 低频线谱激励下动力吸振器设计研究［J］. 振动与噪声控制，2019，39(2)：186-194.
HE Huixiong, XIANG Yang, ZHANG Bo. Research of the Design of Dynamic Vibration Absorbers under Low Frequency Line Spectrum Excitations［J］. Noise and Vibration Control, 2019, 39(2)：186-194.
［2］SNOWDON J C, WOLFE A A, KERLIN R L. The Cruciform Dynamic Absorber［J］. Journal of the Acoustical Society of America, 1984, 75:1792-1799.
［3］陈果，程小勇，刘明华，等. 用于管道减振的新型动力吸振器［J］. 中国机械工程，2014，25(23)：3125-3131.
CHEN Guo, CHENG Xiaoyong, LIU Minghua, et al. A New Type of Dynamic Vibration Absorber for Pipe System Vibration Suppression［J］. China Mechanical Engineering, 2014, 25(23)：3125-3131.
［4］王文初，尹志勇，陈科，等. 新型三向管路动力吸振器设计方法研究［J］. 船舶力学，2015，19(1/2)：191-197.
WANG Wenchu, YIN Zhiyong, CHEN Ke, et al. Research on Design Method for a New Type 3D Pipeline Damper［J］. Journal of Ship Mechanics, 2015, 19(1/2)：191-197.
［5］LENZ J. Magic Cube-three Dimensional Vibration Absorber for Pipeline Vibrations［C］∥International Compressor Engineering Conference. Purdue, 2008：1337.1-1337.8.
［6］CHUN S, LEE Y, KIM T. H∞ Optimization of Dynamic Vibration Absorber Variant for Vibration Control of Damped Linear Systems［J］. Journal of Sound and Vibration, 2015, 335：55-65.
［7］邢昭阳，申永军，邢海军，等. 一种半主动负刚度动力吸振器［J］. 振动与冲击，2021，40(15)：123-128.
XING Zhaoyang, SHEN Yongjun, XING Haijun,et al. A Semi-active Negative Stiffness Dynamic Vibration Absorber［J］. Journal of Vibration and Shock, 2021, 40(15)：123-128.
［8］刘璞，方鹏，张锐，等. 两级串联式动力吸振器的参数设计［J］. 振动与噪声控制，2020，40(2)：226-229.
LIU Pu, FANG Peng, ZHANG Rui, et al. Parameter Optimization of Double-series-mass Dynamic Vibration Absorbers［J］. Noise and Vibration Control, 2020, 40(2)：226-229.
［9］林武斌，滕汉东. 动力吸振在输油泵机组垂向减振中的应用研究［J］. 振动与冲击，2020，39(12)：289-293.
LIN Wubin, TENG Handong. Application of Dynamic Vibration Absorbers in the Vertical Vibration Reduction of Oil Pump Unit［J］. Journal of Vibration and Shock, 2020, 39(12)：289-293.
［10］刘刚, 郑大胜, 丁志雨，等. 变质量-负刚度动力吸振器试验研究［J］. 中国机械工程，2018，29(5)：538-543.
LIU Gang, ZHENG Dasheng, DING Zhiyu, et al. Experimental Study on Variable Mass Negative Stiffness Dynamic Vibration Absorbers［J］. China Mechanical Engineering, 2018, 29(5)：538-543.
［11］赵艳青, 夏晶晶, 高强．变质量颗粒阻尼吸振器及其宽频减振性能［J］. 中国机械工程，2015，26(19)：2571-2580.
ZHAO Yanqing, XIA Jingjing, GAO Qiang.VMTPD and Its Performance of Wideband Vibration Reduction［J］. China Mechanical Engineering, 2015, 26(19)：2571-2580.
［12］刘耀宗，郁殿龙，赵宏刚，等. 被动式动力吸振技术研究进展［J］. 机械工程学报，2007，43(3)：14-21.
LIU Yaozong, YU Dianlong, ZHAO Honggang, et al. Review of Passive Dynamic Vibration Absorbers［J］. Chinese Journal of Mechanical Engineer, 2007, 43(3)：14-21
［13］黄真, 赵永生, 赵铁石. 高等空间机构学［M］. 北京：高等教育出版社, 2006：106-108.
HUANG Zhen, ZHAO Yongsheng, ZHAO Tieshi. Advanced：Spatial Mechanism［M］. Beijing：Higher Education Press, 2006:106-108.
［14］MAHAJAN S, REDFIELD R. Power Flow in Linear, Active Vibration Isolation Systems［J］. Journal of Vibration & Acoustics, 1998, 120(2)：1125-1132.

[1]	LI Meng-Lei, GU Yo-Qin, ZHANG Hua-Liang, LIU Li-Qin, DU Juan, WEN Chu-Hua, LAN Guo-Sheng. Parallel Mechanism Structure Optimization Design Based on Multi-objective Differential Evolution Algorithm [J]. J4, 201016, 21(16): 1915-1920.
[2]	LU Kai-Jiang, SHI Dun-Beng, ZHANG Feng-Chao. Dynamics Optimization Design of Planar 3-DOF Parallel Mechanism [J]. J4, 201016, 21(16): 1926-1931.
[3]	PU Zhixin, GUO Jianwei, PAN Yuqi, BAI Yangxi. Performance Analysis and Optimization Design of 2PPaPaR Parallel Mechanism [J]. China Mechanical Engineering, 2023, 34(19): 2304-2312.
[4]	SHEN Huiping, LI XiaLI Ju, LI Tao, MENG Qingmei, WU Guanglei. Effect of Constrained or Unconstrained Branches on Kinematics and Stiffness Performance of PMs —Design，Analysis and Optimization of Two Novel Three-translation PMs with Partial Motion Decoupling Being Examples#br# [J]. China Mechanical Engineering, 2023, 34(13): 1533-1549.
[5]	DU Zhongqiu, SHEN Huiping, MENG Qingmei, LI Tao, YANG Tingli. Design and Performance Analysis of 8R Two-translational Spatial Parallel Mechanism with Motion Decoupling and Symbolic Positive Solutions [J]. China Mechanical Engineering, 2023, 34(12): 1425-1435.
[6]	CHEN Hengtong, WANG Xiaoguang, JIANG Hailong, LIN Qi. Analysis and Comparison of Kinematic Characteristics for Two Typical 6-DOF Suspension Mechanisms at High Angles of Attack [J]. China Mechanical Engineering, 2023, 34(06): 641-649.
[7]	LIAO Cancan, ZHANG Yuanyuan, MO Han. Optimal Design of Tracking Mechanisms for a New Type Dish Solar ConcentratorLIU Fanmao [J]. China Mechanical Engineering, 2023, 34(04): 395-403.
[8]	WANG Manxin, LI Lanbin, LI Zhengliang, LIU Haitao, HUANG Tian. Topological Structure Synthesis and Optimization of 1T2R Parallel Mechanisms [J]. China Mechanical Engineering, 2022, 33(20): 2395-2402.
[9]	WANG Yixi, SHEN Huiping, CHEN Pu, WU Guanglei. Three-level Orderly Proceeding Optimization Design and Its Applications for Parallel Mechanisms Based on Kinematics，Stiffness and Dynamics [J]. China Mechanical Engineering, 2022, 33(13): 1560-1575,1621.
[10]	ZHU Yaguang, ZHU Jianwei, LI Ruyue, SONG Zhipeng. Neuromuscular Architecture Based Compliance Control of Bionic Parallel Torsos [J]. China Mechanical Engineering, 2022, 33(13): 1576-1585,1637.
[11]	ZHANG Yanbin, WANG Keming, LU Fenglin, WEI Xuemin, WANG Kefeng. Type Synthesis of Uncoupled Two-rotational Parallel Mechanism with One Pure Constraint Branch [J]. China Mechanical Engineering, 2022, 33(01): 54-61.
[12]	ZHANG Ying, SUN Hao, MA Shuaishuai. Design of a Kind of Multi-dimensional Attitude Adjustment and Vibration Isolation Platform Based on 4-UPS/CPC Parallel Mechanisms#br# [J]. China Mechanical Engineering, 2021, 32(13): 1513-1522,1529.
[13]	GONG Junshan;FANG Yuefa;JIN Xiaodong. Design and Research of Multifunctional Dexterous Hands Based on Parallel Finger Structure [J]. China Mechanical Engineering, 2020, 31(23): 2837-2846.
[14]	WANG Yixi1;WU Guanglei2;SHEN Huiping1;LI Jiayu1;MENG Qingmei1;LI Ju1;DENG Jiaming1. Stiffness Modeling and Analysis of Semi-symmetrical Three-translation Delta-CU Parallel Mechanism [J]. China Mechanical Engineering, 2020, 31(17): 2050-2058.
[15]	SHEN Huiping, XU Ke, YANG Tingli. A Novel Forward Position Kinematics Modelling Principle for Mechanisms Based on Ordered Solutions for SOC Units and Its Two Solving Methods [J]. China Mechanical Engineering, 2020, 31(14): 1647-1658.